Transcol RF21 Thin Rehabilitate Facades White
Hydrophobic dry mortar with high hardness and resistance to water penetration. Developed for fine-coat finishes in the renovation of old and new hydraulic plasters, addressing random cracks caused by mortar shrinkage.
Substrate
Apply to new or old plaster or concrete.
The support must be at least 14 days old, and if exposed to intense sunlight, lightly dampen the surface 20 minutes before application. In specific cases, apply a surface regulator or, in the case of supports of different nature, apply Transcol Parget.
Application Method
The mixture can be prepared manually, using a low-speed mixer.
Mix the contents of the 25 kg bag with 4.5 liters of clean water until a homogeneous mixture is obtained, free of lumps.
Once mixed, the mortar should be applied within the next 30 minutes, without adding more water after mixing.
Apply with a float, spreading the mortar in a uniform layer with a thickness no less than 4 mm.
After application, regularize the surface 10 to 15 minutes later with a trowel, and finally finish with a sponge to obtain a rough finish.
Transcol RF (Thin Rehabilitate Facades) does not replace painting.
Safety
It is recommended to use a dust mask to protect the respirable crystalline silica, goggles and gloves when handling the product. If there is contact with eyes, rinse thoroughly with clean water. Do not ingest.
Technical Information
📋 Technical Data Sheet
Where to buy
Find the closest reseller to you!
Discover our range of Rehabilitation Mortars
Do you have any questions?
