Transcol Exterior White Plaster With Fibers
Hydrophobic construction mortar with added glass fibers for crack resistance.
Substrate
Apply on ceramic brick masonry, cement blocks, and concrete.
It should be applied on a flat and regular surface, correcting it if necessary.
If the surface is too dry, lightly moisten it 20 minutes before application, or in specific cases, apply a surface regulator and/or in cases of surfaces of different nature, apply Transcol Parget.
If the surface is concrete, apply a water-based bonding agent, such as the Transcol Adere-P product.
Application Method
The mixture can be prepared manually, using a concrete mixer or a mixing machine.
Mix the contents of the 25 kg bag with approximately 4 to 4.5 liters of clean water until a homogeneous mixture without lumps is obtained.
Once mixed, the mortar must be applied within 30 minutes without adding more water after mixing.
Spread the mortar evenly in a layer of 15 to 20 mm thickness.
For fillings greater than 20 mm, apply in two layers, both with similar thicknesses, ensuring the lower layer has already set.
After application, level the surface with a straightedge, and depending on the desired finish, you can use a trowel for ceramic coatings, ornamental stone, thick coatings, and/or sponge for a smooth painting finish.
The curing time for Transcol Exterior Plaster with Fibers is 28 days, and it does not replace painting.
Safety
It is recommended to use a dust mask to protect the respirable crystalline silica, goggles and gloves when handling the product. If there is contact with eyes, rinse thoroughly with clean water. Do not ingest.
Technical Information
📋 Technical Data Sheet
Where to buy
Find the closest reseller to you!
Related Products
Discover our range of Plasters
Do you have any questions?
