Transcol Parget
Technical mortar used for rough-coating interior and exterior walls and ceilings, leaving a porous surface to enhance adhesion for finishing mortars.
Substrate
Suitable for coating brick, cement blocks, or concrete before plastering.
Thoroughly moisten the surface to ensure it is neither too dry nor too wet.
Application Method
The mixture can be prepared manually, using a concrete mixer or a mixing machine.
Mix the contents of the 25 Kg bag with approximately 3 to 4 liters of clean water, until a homogeneous, lump-free mixture is obtained.
Once mixed, the mortar must be applied within the next 30 minutes, without adding more water after mixing.
Apply Transcol Parget in a single, uniform layer, covering the entire wall or ceiling with a thickness of 3 to 5 mm.
After application, wait 24 hours before applying a finishing mortar.
Safety
It is recommended to use a dust mask to protect the respirable crystalline silica, goggles and gloves when handling the product. If there is contact with eyes, rinse thoroughly with clean water. Do not ingest.
Technical Information
📋 Technical Data Sheet
Where to buy
Find the closest reseller to you!
Related Products
Discover our range of Technical Mortars
Do you have any questions?
