Transcol H₂O Adhesive
Cement-based construction adhesive, suitable for laying and grouting ceramics, marble, mosaic, and tiles up to 400 cm², in water reservoirs and swimming pools.
Substrate
Apply to cement or masonry walls or floors.
Concrete or masonry walls and floors must be at least 30 days old, while plaster and screeded mortar must be at least 14 days old.
Application Method
The mixture should preferably be made mechanically, using a low-speed mechanical stirrer.
Mix the contents of the 25 kg bag with approximately 6 to 6.5 liters of clean water until a homogeneous mixture is obtained, free of lumps.
Spread the adhesive evenly using a notched trowel (6 to 8 mm) and then place the piece to be bonded, pressing it with vibrating movements until a layer of approximately 4 mm thickness is achieved.
Allow for joints of at least 2 mm between the pieces, which should be filled with mortar and joint compound capable of absorbing the dimensional variations of the pieces.
Joint filler can be applied between 24 to 48 hours after bonding.
Whenever higher efficiency or bonding of larger pieces is required, a double bonding method should be used. This method applies to pieces larger than 625 cm² and in high-traffic areas.
Once applied, the adhesive allows for a 30-minute adjustment time.
Safety
It is recommended to use a dust mask to protect the respirable crystalline silica, goggles and gloves when handling the product. If there is contact with eyes, rinse thoroughly with clean water. Do not ingest.
Technical Information
📋 Technical Data Sheet
Where to buy
Find the closest reseller to you!
Related Products
Discover our range of Construction Adhesives
Do you have any questions?
